Concept One

This Method is Easiest one .

This Method is Based on simple Air Force by Fans to lift a Body .

Note :- This is a Totally assumed method , please try this if you totally agree and have calculations required.

Important Points:-

1.  The Hoverboard will Basically work on Two Fans to get  Lift/Flight.

2.  The Hoverboard will be using Lithium ion Batteries to get a high voltage.

3. It will be using Some special components and circuits.

4. It will be made up of regular Plastic or Carbon Fibre.

Things you will need :-

1. Plastic moulded  / Carbon Fibre Moulded Board. { QTY:- 1}

2. Rotatory ( Middle ) part of Ceiling Fan. {QTY:- 2}

3. Circuit board ( PCB ). {QTY:- 1}

4. Oscillator ( 50 Hz Freq. ). {QTY:- 2}

Note :- If you didn't get this thing then simply goto Here

5. Voltage Regulator ( 200 V to 260 V ). {QTY:- 2}

Note :- If you didn't get this thing then you can buy it here .

6.  Lithium-ion Battery ( 300 V ). {QTY:- 1}

Note :- Most probably you'll not be getting a rechargable battery of this value so you have to make your own or use another source.
to make your own with low weight , more efficiency , 500,000-1,000,000 charge cycles . go here

Working :-

When the battery dilivers a sufficient voltage to the circuit then the circuit converts the DC voltage into AC voltage using a Oscillator ( may be Crystal , Regular etc ) and after that the Circuit delivers the AC voltage to Two fans  ( one at front side and one at back side ).

That’s how the board will fly .

Making :-

Step-By-Step

1.  Assemble the parts as shown in picture below :-

 

2. Try different weights on it .


3. If it works then just stand over it  , else try to adjust voltage regulator .

4. Attach charging module to the two pins of battery ( right to PCB )

5.  Done ..... 

Enjoy your simple yet Cool HoverBoard .....